Marantz PM5004 Bedienungsanleitung PDF herunterladen (Seite 11)

ENGLISH

NOTE

• Do not plug in the power cord until all connections have been

completed.

• When making connections, also refer to the operating instructions

of the other components.

• Be sure to connect the left and right channels properly (left with

left, right with right).

• Do not bundle power cords with connection cables. Doing so can

result in humming or noise.

• Do not turn up the volume without a turntable connected to the

PHONO input terminals. Doing so will cause humming or noise.

Preparations

Connecting cables

Select the cables according to the equipment being connected.

Audio cables

Analog connections (stereo)

(White)

(Red)

Stereo pin-plug cable

Speaker connections

Speaker cables

NOTE

• Connect the speaker cables so they do not stick out of the speaker

terminals. The protection circuit may be activated if the wires touch

the rear panel or if the + and – sides touch each other (vpage6

“Protection circuit”).

• Never touch the speaker terminals while the power supply is

connected. Doing so could result in electric shock.

n Protection circuit

The protection circuit is be activated in the following situations:

• If the speaker cable wire touches the rear panel or screws or if

the speaker cable wire touches the speaker cable’s + and – sides

are touching

• If the surrounding temperature is extremely high

• If the inside of the ampliﬁ er gets hot to extended use at a high

output

If the protection circuit is activated, the speaker output is blocked

and the power indicator ﬂ ashes in red. If this happens, unplug the

power cord, then check the connections of the speaker cables and

input cables. If the unit becomes very hot, wait for it to cool off and

improve the ventilation around it. After doing this, plug the power

cord back in.

If the protection circuit is activated even though there are no

problems with the ventilation around the unit or in connections,

the unit may be damaged. Turn off the power and then contact a

Marantz service center.

Basic connections

Connecting the speakers

Connecting the speakers cables

Carefully check the left (L) and right (R) channels and + (red) and –

(black) polarities on the speakers being connected to the unit, and be

sure to connect the channels and polarities correctly.

Peel off about 10 mm of sheathing

from the tip of the speaker cable,

then either twist the core wire tightly

or apply solder to it.

Turn the speaker terminal

counterclockwise to loosen it.

Insert the speaker cable’s core

wire to all the way into the speaker

terminal.

Turn the speaker terminal clockwise

to tighten it.

Connecting the audio equipment

Cautions on playing SA(Super Audio) sources:

When regular speakers not compatible with SA sources (DVD Audio discs, Super Audio CDs and other sources, including treble components

above the audible range), set the properties of the player (DVD Audio player, Super Audio CD player, etc.) for use with regular speakers (or

ampliﬁ ers).

The speakers may be damaged if the volume is set too high when playing SA sources. For instructions on player settings, refer to the

operating instructions included with the player.

1.PM5004_N_ENG_校了.indd Sec1:61.PM5004_N_ENG_校了.indd Sec1:6 2010/05/20 20:24:452010/05/20 20:24:45

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

Marantz PM5004 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Akustik Marantz PM5004